Nokia Essential Wireless Headphones E1200 User Manual

Nokia Essential Wireless Headphones E1200 User Manual : Let’s unbox the user manual of Nokia Essential Wireless Headphones E1200.

Nokia Essential Wireless Headphones E1200 User Manual

Nokia Essential Wireless Headphones E1200 User Manual
Nokia Essential Wireless Headphones E1200 User Manual

Specifications

Wearing styleWireless Headphones
Ear couplingCircumaural
Frequency response20 Hz to 20kHz
Transducer principleDynamic, closed
Transducer size40mm
Sound pressure level(SPL)106dB(1kHz/ 1mW)
Impedance32Ω
Microphone principleECM x1
Power supplyBuilt-in Lithium rechargeable batteries,
3.7V, 500mAh
Operating time40 hours (music playback via A2DP)*
Charging timeApprox. 3 hours
WeightApprox. 197g
Volume ControlYes

Bluetooth

VersionBluetooth specification version 5.0
ProfilesHFP, AVRCP, A2DP
Effective RangeLine of sight approx. 30ft (10m)
Transmission frequency2402 MHz to 2480 MHz
Supported Audio Format(s)SBC

Contents

Nokia Essential Wireless Headphones E1200 Contents
Nokia Essential Wireless Headphones E1200 Contents

Powering On

Nokia Essential Wireless Headphones E1200 Powering On
Nokia Essential Wireless Headphones E1200 Powering On

Pairing Mode

Nokia Essential Wireless Headphones E1200 Pairing Mode
Nokia Essential Wireless Headphones E1200 Pairing Mode

Reset

Nokia Essential Wireless Headphones E1200 Reset
Nokia Essential Wireless Headphones E1200 Reset

Controls

Nokia Essential Wireless Headphones E1200 Controls
Nokia Essential Wireless Headphones E1200 Controls

Charging

Nokia Essential Wireless Headphones E1200 Charging
Nokia Essential Wireless Headphones E1200 Charging

Troubleshooting

ProblemReasonSolution
Does not power on /
Does not respond
Battery is lowCharge the headphones
for 2 – 3 hours and
restart the headphones
No sound after
pairing
Incorrect pairingPair the headphones again
or reset the headphones
Turns off
automatically
Battery is lowCharge the headphones
for 2-3 hours
Red light flashes
on headphones
Battery is lowCharge headphones
Failing to chargeError with power supplyPerform a hardware reset
No light when
charging
Error with power supplyCheck charging cable is
plugged in and ensure
that it is switched on
Hearing an echoVolume is too loud
or the environment
is too noisy
Adjust the volume or
change your location
Noise in-callNoisy environment or
distance between
earphones and mobile
phone is too far
Change your location or
bring your earphones and
mobile phones closer
together
Sound occasionally
drops
Environmental
interference or
out of Bluetooth
transmission range
Change location with less
signal interference or
reduce the distance
between the headphones
and devices
Sound is too softLow volumeIncrease the volume

Safety guide

Important safety instructions

  • Read the user guide & warranty manual (as supplied) carefully and completely before using the product.
  • Always include this safety guide when passing the product on to third parties.
  • Do not use an obviously defective product.
  • Use only the product in environments where wireless Bluetooth transmission is permitted.

Preventing damage to health and accidents

  • Do not listen at high volume levels for long periods of time to prevent hearing damage.
  • The product generates stronger permanent magnetic fields that could cause interference to cardiac pacemakers, implanted defibrillators (ICDs) and other implants. Always maintain a distance of at least 3.94” (10cm) between the product component containing the magnet and the cardiac pacemaker, implanted defibrillator or other implant.
  • Keep the product, accessories and packaging parts out of reach of-children and pets to prevent accidents. Swallowing and choking hazard.
  • Do not use the product in an environment that requires your special-attention (e.g. in traffic).

Preventing damage to the product and malfunctions

  • Always keep the product dry and do not expose it to extreme temperatures (hairdryer, heater, extended exposure to sunlight, etc.) to avoid corrosion or deformation. The normal operating temperature is from 0 °C to 40 °C/32 °F to 104 °F.
  • Use only attachments/accessories/spare parts supplied or recommended by RichGo.
  • Only clean the product with a soft, dry cloth.

Source

Read More

Leave a Comment