Otium Solo Wireless Headphones User Manual

Otium Solo Wireless Headphones User Manual : In this user manual guide, we will review the Otium Solo Headphones user manual.

Otium Solo Wireless Headphones User Manual

Otium Solo Wireless Headphones User Manual
Otium Solo Wireless Headphones User Manual

Specifications

Bluetooth VersionV4.0
Audio InputAux
Receiving range10 meters without obstacle
Impedance32ohm+10%
Driver Unit2*40mm speaker
Working Voltage3.7V
Sensitivity105+5dB at 1KHz
Max output power30mW
Audio jack3.5mm
Frequency Response20Hz-20KHz
Built in Battery300mAh/Up to 10 hours music time
Charging Time<2.5 hours
Talking TimeAbout 18 hours
Standby TimeAbout 200 hours

Packing List

  1. Headphone *1
  2. USB cable *2
  3. User Manual *3
  4. AUX cable *4

Kind Reminder

  1. To prolong the headphones life span and to fend off hearing loss, please do not listen to music at high volume for a long time.
  2. When an error occurs with the headphones, please turn off the product are reboot.
  3. When the headphones power is low, the Bluetooth range may be affected. Please charge the headphones to avoid disruptions during use.

Overview

Otium Solo Wireless Headphones Overview
Otium Solo Wireless Headphones Overview

Function Keys

  1. Next song/Increase volume: Short press the “+” button to next song /Long press the “+” button to increase the volume.
  2. Previous song/Reduce volume: Short press the “-” button skip to previous song /Long press the button “-” to reduce the volume.
  3. On/Off: Press and hold for 3 seconds to turn the headphones On or Off.

Bluetooth Operation

  1. Turn the headphone on by pressing the power button for 3 seconds to enter into the pairing mode, the red and blue light would flash alternately, and the headphone would enter Bluetooth searching state automatically. After pairing successfully, the blue light would flash up; but it fail, it would automatically shut down within 5 minutes. If the connection fails, please restart or charge the headphone, since a low battery would cause to shutdown.
  2. After connecting to the phone successfully, the headphone would beep when there is an incoming call.

AUX Operation

  1. Insert a 3.5mm audio cable into the AUX jack on the back of the headphone. Connect the 3.5mm cable to any audio device with a port.
  2. Plug the audio line into the AUX audio input of the headphone and other audio devices like computer. The Bluetooth should still be on while plugging an aux line, otherwise, the operations would be invalid.

Common Problem Solution

PROBLEMTROUBLESHOOTING
Repeated failure of connection1. Make sure the headphone is in searching mode, or try to reboot.
2. Turn off other Bluetooth devices which would affect searching.
Small or distorted sound1. Detect the volume of the headphone, and adjust to an appropriate volume.
2. Low battery, please fully charge and try again.
Discontinuous musicMove the paired Bluetooth device closer to the headphones. Make sure there are no obstacles between the Bluetooth device and the headphones.
Bluetooth indicator light does not show up1. Low battery, please fully charge and try again.
2. Reboot

Notice

  • Please keep and use this product in a normal temperature.
  • Do not expose this product to a damp environment.
  • Do not throw or drop this product.
  • Do not disassemble, repair, or modify this product.
  • This product has a lithium battery, to avoid danger.
  • Do not close to fire.

Source

Read More

Leave a Comment