If you are searching for Soundcore Liberty 3 Pro True Wireless Earbuds User Manual then this is the right place for you.
Soundcore Liberty 3 Pro True Wireless Earbuds User Manual
Wearing
Choose the Earwings that fit your ears best. Twist the earbuds until the Earwings are wedged against the ridge of your ears.
Charging
- Fully dry off the earbuds and the USB-C charging port before charging.
- Use an original or a certified USB-C charging cable to prevent any damage.
- For wireless charging, position the charging case at the center of your wireless charger.
Power On/Off
- Open the charging case, the earbuds will automatically power on. To power off, place the earbuds in the charging case and close it.
- To manually power on, wear both earbuds, then press and hold the touchpad on both earbuds for 3 seconds.
Automatic Pairing
- Open the charging case, the earbuds will automatically enter Bluetooth pairing mode.
- Select “Soundcore Liberty 3 Pro” on your device’s Bluetooth list to connect.
Manual Pairing
Place the earbuds in the charging case and leave the case open, then press and hold the button on the charging case for 3 seconds until the LED indicators flash white.
Controls
*2: Tap twice
- 1s: Press and hold for 1 seconds.
- 2s: Press and hold for 2 seconds.
Ambient Sonud
You can switch Hear ID ANC mode or transparency mode to normal mode in the Soundcore app.
- Hear ID ANC: Take the ear canal test and tailor your noise cancellation experience.
- Transparency: Stay aware of your surroundings while listening to music.
LDAC
- Use device powered by Android 8.0 or later to experience LDAC quality sound.
- You can enable or disable LDAC using the Soundcore App.
Wearing Detection
The playback will automatically pause when removing either earbud and will resume when wearing it again.
Wear either earbud to automatically answer an incoming call.
Multipoint
- The earbuds can connect with two Bluetooth devices at the same time.
- To pair with another device, wear the earbuds, then press and hold the touchpad on both earbuds for 5 seconds simultaneously.
Reset
- Reset if the earbuds cannot properly pair with each other or with other device.
- Delete the pairing history from your Bluetooth device first.
- Place the earbuds into the charging case and leave the case open. Press and hold the button on the case for 10 seconds until the LED indicators rapidly flash white 3 times.
LED Light Guide
- Steady White
- Flashing White
- Breathing White
- Light Off
Source
- soundcore.com
- Download User Manual – Download
- Product Page – Click Here
Read More