Urbanears Alby Bluetooth Earbuds User Manual

Urbanears Alby Bluetooth Earbuds User Manual : Let’s unbox the user manual of Urbanears Alby bluetooth earbuds.

Urbanears Alby Bluetooth Earbuds User Manual

Urbanears Alby Bluetooth Earbuds User Manual
Urbanears Alby Bluetooth Earbuds User Manual

First time setup

  1. Open the case and take the earbuds out.
  2. Remove the protective plastic strips and put the earbuds back in the case.
  3. Take out the earbuds, wait 5 seconds and put them in your ears.
  4. Select Urbanears Alby from your device’s Bluetooth menu.

Touch control

Double tap any earbud: Play/pause, answer a call or hang up.

Charging case

Put your earbuds back into the case to recharge, a fully charged case can recharge both earbuds up to 4 times. The LED indicator on the case shows its battery level, from green (full), through orange to red (low). Connect the case to a USB power source via the included USB-C cable to charge it. When your earbuds are in the case, they turn off. Taking them out will turn them on and try to reconnect.

Overview

Earbuds

  1. Touch control surface.
  2. Earbud LED indicator.
  3. Microphone for phone calls.
  4. Removable ear tips (S/M/L).

Charging case

5. Case battery LED indicator.

6. USB-C port for charging.

Urbanears Alby Bluetooth Earbuds Overview
Urbanears Alby Bluetooth Earbuds Overview

Pairing with another device

You can easily change from one connected device to another.

  1. Open the Bluetooth menu on the device that your earbuds are currently connected to and disconnect Urbanears Alby.
  2. The earbuds are now in pairing mode and ready to connect.
  3. Open the Bluetooth menu on the device you want to connect to and select Urbanears Alby.

Resetting your earbuds

If you have problems pairing your earbuds or they become erratic or unresponsive, perform a hardware reset.

  1. Put the earbuds in the charging case.
  2. Take out the earbuds of the case.

If the problem persists, perform a factory reset.

Note: This will delete all information about previous paired devices.

  1. Take out the earbuds and put them in your ears.
  2. Press and hold the touch control surface on both earbuds for 7 seconds, until they turn off.
  3. Press and hold the touch control surface on both earbuds for 10 seconds. You will hear the earbuds turn on, initiate Bluetooth pairing and then power off.
  4. Put your earbuds back in the charging case and they will be reset to factory settings.

Pairing after factory reset

  1. Open the Bluetooth menu on the device that your earbuds were previously connected to and remove Urbanears Alby.
  2. Take out the earbuds, wait 5 seconds and then put them in your ears.
  3. Select Urbanears Alby from your device’s Bluetooth menu.

Source

Read More

Leave a Comment