If you are looking for Urbanista LOS ANGELES Headphones User Manual then you are at the right place.
Urbanista LOS ANGELES Headphones User Manual
URBANISTA LOS ANGELES
Thank you for choosing an Urbanista product.
FIRST TIME PAIRING AND RECONNECTING
Press and hold the “Control Button” (1) for 1 second. Your headphones will turn on and automatically enter pairing mode.
Open Bluetooth settings on your device and select “Urbanista Los Angeles”. The “Battery Status Indicator” (2) will flash to indicate pairing mode and stop flashing when successfully paired.
The headphones will automatically reconnect to the same device you have paired them to when next turned on.
CONNECT TO ANOTHER DEVICE
Disconnect the headphones from the device to enter pairing mode again or to connect to another device. The headphones can store up to six paired devices.
CHARGING AND BATTERY
Urbanista Los Angeles has a built-in PowerfoyleTM solar cell that continuously charges your headphones whenever exposed to any light providing you with virtually infinite playtime. The self-charging occurs in direct and indirect solar light as well as indoor light, but the stronger the light, the more effective. When you are not using your headphones, place them somewhere where the PowerfoyleTM area is exposed to light, for example, a windowsill.
In addition, Los Angeles has a battery saving feature that will automatically power off the headphones if Bluetooth is disconnected for 5 minutes or if the headphones are not worn for 30 minutes.
Should the battery for some reason run low, a “Battery low” voice prompt will notify you when there are 30 minutes of playtime remaining, after which the headphones will automatically turn off.
Use the included USB Type-C cable connected to a power source to charge the headphones. The “Battery Status Indicator” (2) will lit red continuously when charging and turn white when fully charged.
CONTROLS
POWER ON – Press and hold the “Control button” (1) for 1 second.
POWER OFF – Press and hold the “Control button” (1) for 5 seconds.
PLAY – Press the “Control button” (1) once.
PAUSE – Press the “Control button” (1) once.
ANSWER A CALL – Press the “Control button” (1) once.
END A CALL – Press the “Control button” (1) once.
REJECT A CALL – Press and hold the “Control button” (1) for 2 seconds.
VOLUME UP – Press the “+” button (3) once.
VOLUME DOWN – Press the “–” button (3) once.
NEXT TRACK – Press and hold the “+” button (3) for 2 seconds.
PREVIOUS TRACK – Press and hold the “-” button (3) for 2 seconds.
ACTIVE NOISE CANCELLING – Press the “Feature button”(4) one time.
AMBIENT SOUND MODE – Press the “Feature button” (4) a second time.
DEFAULT MODE – Press the “Feature button” (4) a third time to return to default mode.
VOICE ASSISTANT – Press the “Feature button” (4) for 2 seconds.
RESET
To reset your Los Angeles headphones to the default settings, please follow the below steps.
- Delete the “Urbanista Los Angeles”from the Bluetooth settings on your device.
- From power off, press and hold the “Control button”(2) for 10 seconds until the battery status indicator flashes quickly, then release the button.
- Follow the instructions in “First Time Pairing and Reconnecting”to reconnect to your headphones.
TROUBLESHOOTING
If you have any additional questions, please visit our online help center where you will find our FAQs and an online version of this manual:
https://support.urbanista.com/
Source
- urbanista.com
- Download User Manual – Download
- Product Page – Click Here
Read More