Urbanears Luma Bluetooth Earbuds User Manual

by

Urbanears Luma Bluetooth Earbuds User Manual : In this user manual guide, We will see the urbanears luma bluetooth earbuds manual.

Urbanears Luma Bluetooth Earbuds User Manual

Urbanears Luma Bluetooth Earbuds User Manual
Urbanears Luma Bluetooth Earbuds User Manual

First time setup

  1. Open the case and take the earbuds out.
  2. Remove the protective plastic strips and put the earbuds back in the case.
  3. Take out the earbuds and put them in your ears.
  4. Select Urbanears Luma from your device’s Bluetooth menu.

Touch control

Double tap any earbud: Play/pause, answer a call or hang up.

Triple tap the left earbud: Previous song.

Triple tap the right earbud: Next song.

Press and hold (2s) any earbud: Voice assistant.

Wireless charging case

Put your earbuds back into the case to recharge, a fully charged case can recharge both earbuds up to 5 times. The LED indicator on the case shows its battery level, from green (full), through orange to red (low). Place the case on a wireless charger or connect it to a USB power souce via the included USB-C cable. When your earbuds are in the case, they turn off. Taking them out will turn them on and try to reconnect.

Overview

  1. Touch control surface.
  2. Earbud LED indicator.
  3. Microphone for phone calls.
  4. Auto-pause sensor.
  5. Case battery LED indicator.
  6. USB-C port for charging.
Unbanears Luma Bluetooth Earbuds Overview
Unbanears Luma Bluetooth Earbuds Overview

Pairing with another device

You can easily change from one connected device to another.

  1. Open the Bluetooth menu on the device that your earbuds are currently connected to and disconnect Urbanears Luma.
  2. The earbuds are now in pairing mode and ready to connect.
  3. Open the Bluetooth menu on the device you want to connect to and select Urbanears Luma.

Resetting your earbuds

If you have problems pairing your earbuds or they become erratic or unresponsive, perform a hardware reset.

  1. Put your earbuds in the charging case.
  2. Take out your earbuds of the case.

If the problem persists, perform a factory reset.

  1. Put your earbuds in the charging case.
  2. While in the case, press and hold the touch control surface on both earbuds for 10 seconds.
  3. Take out the earbuds and put them in your ears.
  4. Double tap both earbuds and they will be reset to factory settings.

Pairing after factory reset

  1. Open the Bluetooth menu on the device that your earbuds were previously connected to and remove Urbanears Luma.
  2. Take out the earbuds, wait for 5 seconds and put them in your ears.
  3. Select Urbanears Luma from your device’s Bluetooth menu.

Source

Read More

Leave a Comment